Floor Warming Accessories

Accessories include audible continuity monitor, cable strapping,
i.d. plaque, clips and screws.

ClipStrip Strapping - for 2FW Cable

Galvanized stainless steel strapping is designed for anchor 2FW cable to the subfloor in an easy consistent pattern.

The punched tabs are spaces 1" (2.5cm) apart.

Each ClipStrip roll is W/L .5"/25' (1cm/8m)

PPS-GS/SS Strapping - for M.I. Cable

The PPS-GS-75 or PPS-SS-75 pre-punched strapping is used to anchor M.I. snow melting cable assemblies at a consistent spacing to the base asphalt pour.

The pre-punched tabs are spaced 1" (2.5cm) apart.

 

FW-CS

The FloorWarner test unit will sound an audible alarm if the cable conductor is broken or cut, or if the cable is pinched or crushed.

With the test unit installed rest assured your floor warming cable is intact during the course of your floor construction.

Remember to never use the FloorWarner with power attached to the heating cable.

Hioki Hi Tester

An affordable and accurate digital meter for insulation resistance, AC voltage, and total resistance readings.

 

 

 

 

Aluminum Heat Transfer Tape

Cover your floor warming cable with aluminum heat tape before embedding to speed up the rate of heat transfer.